含不凝气蒸汽在锯齿形表面的凝结传热特性

doi:10.6040/j.issn.1672-3961.0.2020.295

摘要/Abstract

摘要： 为了在含不凝气蒸汽凝结过程中获得更高的热效率,提出新型锯齿形强化板并建立其二维模型,使用Fluent软件对锯齿形强化板和相同规格波纹板的凝结传热特性进行对比研究。建立可同时计算不凝气层及液膜层的凝结传热模型并在数值模拟中通过用户自定义函数进行编译,模型的可靠性通过和相同工况下的试验进行对比得到验证。数值模拟得到两种板型表面的两相流动及热质交换特征,发现相比于波纹板,锯齿形板能够显著提高不凝气层的紊流度,利于相界面处传热传质过程的进行;锯齿形板的液膜会在波节的齿峰处产生周期性的断裂后在下游壁面上重新形成并在波谷处达到最大厚度;相比于波纹板,在所研究工况内锯齿形板的换热能力总体提高60%以上。

关键词: 锯齿形板, 数值模拟, 凝结传热, 不凝气, 液膜

Abstract: To obtain higher thermal efficiency in the condensation process of steam containing non-condensing gas, a new sawtooth heat transfer strengthening plate was proposed and its two-dimensional model was established. The difference of condensation heat transfer characteristics between serrated plate and corrugated plate with the same specification was analyzed by Fluent software. A condensation heat transfer model to calculate both non-condensable gas layer and liquid film layer at the same time was established and compiled by user defined functions in the numerical simulation. The model reliability was verified by comparing with the experimental values in the same working conditions. The two-phase flow and heat and mass transfer characteristics of different plate surfaces are obtained, and the results showed that compared with the corrugated plate, the sawtooth plate could significantly improve the turbulence of the non-condensable gas layer, which was beneficial to the heat and mass transfer process on the liquid film surface. The liquid film of the sawtooth plate would be periodically fractured at the tooth peak of the wave node and then re-formed on the downstream wall surface and reached the maximum thickness at the trough. Compared with the corrugated plate, the heat transfer capacity of the sawtooth plate was improved by more than 60%.

Key words: sawtooth plate, numerical calculation, condensation heat transfer, non-condensable gas, liquid film

中图分类号:

TK124

闫吉庆,王效嘉,田茂诚. 含不凝气蒸汽在锯齿形表面的凝结传热特性[J]. 山东大学学报 (工学版), 2020, 50(6): 129-134.

YAN Jiqing, WANG Xiaojia, TIAN Maocheng. Condensation heat transfer characteristics of steam containing non-condensable gas on sawtooth surface[J]. Journal of Shandong University(Engineering Science), 2020, 50(6): 129-134.

参考文献

[1] MINKOWYCZ W J, SPARROW E M. Condensation heat trans-fer in the presence of noncondensables, interfacial resis-tance, superheating, variable properties, and diffusion[J]. International Journal of Heat and Mass Transfer, 1966, 9(10): 1125-1144.
[2] 杨宇伟.伴随有凝结发生的椭圆管外对流换热特性的数值研究[D].太原:太原理工大学,2016. YANG Yuwei. Numerical simulation on heat performance outside of elliptical tube heat exchanger with steam condensation[D]. Taiyuan: Taiyuan University of Tech-nology, 2016.
[3] ZSCHAECK G, FRANK T, BURNS A D. CFD modelling and vali-dation of wall condensation in the presence of non-conden-sable gases[J]. Nuclear Engineering and Design, 2014, 279: 137-146.
[4] CHANTANA C, KUMAR S. Experimental and theoretical investigation of air-steam condensation in a vertical tube at low inlet steam fractions[J]. Applied Thermal Engin-eering, 2013, 54(2): 399-412.
[5] SIOW E C, ORMISTON S J, SOLIMAM H M. Two-phase modelling of laminar film condensation from vapour-gas mixtures in declining parallel-plate channels[J]. International Journal of Thermal Sciences, 2007, 46(5): 458-466.
[6] ZHANG Lili, ZHANG Guanmin, TIAN Maocheng, et al. Modeling of laminar filmwise condensation of methane with nitrogen on an isothermal vertical plate[J]. International Communications in Heat and Mass Transfer, 2019, 105: 10-18.
[7] WANG Yungang, ZHAO Qinxin, ZHOU Qulan, et al. Experimental and numerical studies on actual flue gas condensation heat transfer in a left-right symmetric internally finned tube[J]. International Journal of Heat and Mass Transfer, 2013, 64: 10-20.
[8] GANGULI A, PATEL A G, MAHESHWARI N K, et al. Theoretical modeling of condensation of steam outside different vertical geometries(tube, flat plates)in the presence of noncondensable gases like air and helium[J]. Nuclear Engineering and Design, 2008, 238(9): 2328-2340.
[9] KEKAULA K, CHEN Y, MA T, et al. Numerical investigation of condensation in inclined tube air-cooled condensers[J]. Applied Thermal Engineering, 2017, 118: 418-429.
[10] HAMMOUDI D, BENABDESSELAM A, AZZI A, et al. Numerical modeling of steam condensation in vertical channel in presence of noncondensable gas[J]. International Journal of Thermal Sciences, 2018, 126: 263-271.
[11] WANG Xianmao, CHANG Huajian, CORRADIMI M. A CFD study of wave influence on film steam condensation in the presence of noncondensable gas[J]. Nuclear Engineering and Design, 2016, 305: 303-313.
[12] HUANG Jian, ZHANG Junxia, WANG Li. Review of vapor condensation heat and mass transfer in the presence of non-condensable gas[J]. Applied Thermal Engineering, 2015, 89: 469-484.
[13] XU Huiqiang, GU Haifeng, SUN Zhongning. Forced convection condensation of steam in the presence of multicomponent noncondensable gases inside a horizontal tube[J]. International Journal of Heat and Mass Transfer, 2017, 104: 1110-1119.
[14] TANG G, HU H, ZHUANG Z, et al. Film condensation heat transfer on a horizontal tube in presence of a noncondensable gas[J]. Applied Thermal Engineering. 2012, 36: 414-425.
[15] 贾文华. 异形管内混合气体流动凝结换热特性数值模拟[D]. 济南:山东大学, 2019. JIA Wenhua. Numerical analysis on the heat transfer and flow characteristics of condensation in special type heat exchange tube about the mixed gas[D]. Jinan: Shandong University, 2019.
[16] OH S, REVANKAR S T. Experimental and theoretical investigation of film condensation with noncondensable gas[J]. International Journal of Heat and Mass Transfer, 2006, 49(15): 2523-2534.
[17] 唐亮亮. 纯蒸汽与含不凝气蒸汽气泡冷凝过程的数值模拟[D]. 济南:山东大学, 2018. TANG Liangliang. Numerical analysis on condensing process of the steam and the air-steam mixture bubble[D]. Jinan: Shandong University, 2018.
[18] PUNETHA M, KHANDEKAR S. A CFD based modelling approach for predicting steam condensation in the presence of non-condensable gases[J]. Nuclear Engineering and Design, 2017, 324: 280-296.
[19] 衣秋杰. 竖壁外含不凝气体蒸汽凝结传热特性研究[D]. 济南:山东大学, 2018. YI Qiujie. Investigation on the mechanism of steam con-densation heat and mass transfer with non-condensable gas on vertical plate[D]. Jinan: Shandong University, 2018.
[20] YI Qiujie, TIAN Maocheng, YAN Weijie, et al. Visualization study of the influence of non-condensable gas on steam con-densation heat transfer[J]. Applied Thermal Engineering, 2016, 106: 13-21.
[21] CHEN Xianbing, TIAN Maocheng, QU Xiaohang, et al. Numerical investigation on the interfacial characteristics of steam jet condensation in subcooled water flow in a restricted channel[J]. International Journal of Heat and Mass Transfer, 2019, 137: 908-921.

相关文章 15

[1]	刘启明,王文辉,潘英楠,高要辉,郑程程,贺鹏. 厚度缺陷对初支结构安全性的影响及风险评价[J]. 山东大学学报 (工学版), 2025, 55(5): 165-178.
[2]	义扬,肖映雄,余科. 任意多边形骨料混凝土细观模型的建立与数值模拟[J]. 山东大学学报 (工学版), 2025, 55(1): 97-107.
[3]	陈文举, 陈俐企, 包春波, 朱启银, 惠冰, 庄培芝. 循环管道加热桥面融雪效能数值模拟[J]. 山东大学学报 (工学版), 2024, 54(6): 100-110.
[4]	张天旭, 刘延俊, 陈云, 薛钢, 王一铭. 海洋温差循环满液式换热器传热计算方法及试验研究[J]. 山东大学学报 (工学版), 2024, 54(6): 167-175.
[5]	马川义,冯豪杰,蒋红光,侯天新,姚占勇,杨为民. 吸水土工布对路基湿度控制效果的数值模拟[J]. 山东大学学报 (工学版), 2024, 54(4): 141-149.
[6]	韩超,王彤,陈德文,孙恩赐,李平,吴则祥,周冲,庄培芝. 基于耦合欧拉-拉格朗日方法的砂土中静压桩挤土效应数值模拟[J]. 山东大学学报 (工学版), 2024, 54(2): 143-152.
[7]	王钰鑫,吕思忠,姚望,林春金,张明,李召峰,张健,王衍升. 粉质黏土地层桩侧劈裂注浆参数设计与效果评价[J]. 山东大学学报 (工学版), 2023, 53(6): 70-81.
[8]	张亚平,马唯婧,张宸硕,肖辉,张一鸣. 基于图像识别与CAE仿真技术的输变电塔一体化分析[J]. 山东大学学报 (工学版), 2023, 53(6): 122-130.
[9]	宋洋,罗志恒,张波,张宇,朱敏. 裂隙位置对类岩体短柱单轴压缩破坏形态影响[J]. 山东大学学报 (工学版), 2023, 53(5): 121-131.
[10]	王心泉,王智猛,牛犇,蒋恒,冯春. 8度地震烈度区新民隧道出口处边坡的稳定性[J]. 山东大学学报 (工学版), 2023, 53(3): 23-30.
[11]	孙杰,张宏博,程钰,刘羽,张洪波,刘志鲲. 基于TDA填料的废旧轮胎条带加筋砂土边坡承载特性[J]. 山东大学学报 (工学版), 2023, 53(1): 49-59.
[12]	牛犇,张新伟,周玉,李婧,徐兴全,张一鸣. 基于连续-非连续元降雨工况三维边坡稳定性分析[J]. 山东大学学报 (工学版), 2023, 53(1): 92-99.
[13]	郭鹏宁,刘巍,袁浩,冯硕,王延刚. 基于微元离散模型的螺旋挤压脱水效率分析[J]. 山东大学学报 (工学版), 2023, 53(1): 114-121.
[14]	张一鸣,李赟鹏,李婧,丛俊余. 孔隙裂隙介质多场耦合数值计算进展[J]. 山东大学学报 (工学版), 2022, 52(6): 63-78.
[15]	郑卫琴,许杰,孙杰,武科. 复合地层TBM隧道管片受力特征[J]. 山东大学学报 (工学版), 2022, 52(4): 210-213.

多维度评价

Viewed

Full text

Abstract

Cited

Shared

Discussed