JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE) ›› 2016, Vol. 46 ›› Issue (2): 122-127.doi: 10.6040/j.issn.1672-3961.0.2015.373

Previous Articles     Next Articles

Thermoelectric generator system based on engine exhaust gas

MA Zongzheng1,2, SHAO Fengxiang1, WANG Xinli1, YANG Anjie1,2   

  1. 1. School of Mechanical Engineering, Henan University of Engineering, Zhengzhou 451191, Henan, China;
    2. Research Center of Power Machinery and Vehicle Engineering, Henan University of Engineering, Zhengzhou 451191, Henan, China
  • Received:2015-11-17 Online:2016-04-20 Published:2015-11-17

PDF (PC)

1010

Abstract: In order to recycle the waste energy from the exhaust gas of the internal combustion engine, one thermoelectric generator system(TEG)based on the TEG technology was experimentally studied. The test bed was added the temperature, voltage and currency measurement system based on the existing engine test systems firstly. Then the impacts of the internal structure of the heat collector on the TEG performance was got by measuring the temperature and noise variation for different inner structure while the impacts of the radiator cooling methods on the TEG performance was reached by measuring the temperature difference of the both ends and output voltage and currency of the TEG. The results showed that the internal structure of the collector with hollow structure was more conducive to maintain the surface temperature uniformity where the temperature difference was under 6 ℃ for the different points which was helpful to electricity energy output, but this structure was not helpful to reduce noise. It also indicated that forced air cooling method was good for improving the TEG temperature difference and enhancing the electricity energy output which could raise the temperature difference by 14 ℃ compared with naturral air cooling method, but the improvement was not changed when the velocity was higher than a limit value, because the heat transfer efficiency was increased simultaneously for both ends of TEG and more energy was released to the environment. Meanwhile, compared with the side cooling method the facade cooling was better which could raise the temperature difference by 15 ℃ except the single face cooling.

Key words: numerical calculation, cooling method, thermoelectric generator, bench experiment, heat transfer efficiency

CLC Number: 

  • TK417
[1] XU Yong, LI Zuanyi, DUAN Wenhui. Thermal and thermoelectric properties of graphene[J]. Small, 2014, 10(11):2182-2199.
[2] JOKINEN M, MANZANARES J A, KONTTURI K, et al. Thermal potential of ion-exchange membranes and its application to thermoelectric power generation[J]. Journal of Membrane Science, 2016, 499:234-244.
[3] BARMA M C, RIAZ M, SAUDUI R, et al. Estimation of thermoelectric power generation by recovering waste heat from Biomass fired thermal oil heater[J]. Energy Conversion and Management, 2015, 98:303-313.
[4] LEE H, KUNKLE C, WAGNER M F, et al. Solar receiver design for thermoelectric power generation and waste heat utilization: USA, 20150136194[P]. 2015-05-21.
[5] ROWE D M. Thermoelectrics, an environmentally-friendly source of electrical power[J]. Renewable Energy, 1999, 16(4):1251-1256.
[6] SADEGHI H, SANGTARASH S, LAMBERT C J. Oligoyne molecular junctions for efficient room temperature thermoelectric power generation[J]. Nano Letters, 2015, 15(11):7467-7472.
[7] GRAUDEUR D, CRANE S, HUNG B, et al. Automotive waste heat conversion to electric power using skutterudite, TAGS, PbTe and BiTe[J]. Thermoelectrics, 2006(25):343-348.
[8] WOO B C, LEE H W. Relation between electric power and temperature difference for thermoelectric generator[J]. International Journal of Modern Physics B, 2003,17(8):1421-1426.
[9] 马宗正,王新莉. 基于温差发电技术的发动机能量回收研究[J]. 电源技术,2014,38(10):1975-1978. MA Zongzheng, WANG xinli. Development and status of energy recycle for internal combustion engine based on thermoelectric generation[J]. Chinese Journal of Power Sources, 2014, 38(10):1975-1978.
[10] 李茂德,屈健,李玉东,等.接触效应对小型半导体温差发电器性能的影响[J]. 半导体学报,2005,26(12):2440-2444. LI Maode, QU Jian, LI Yudong, et al. Influence of contact effects on properties of a small thermoelectric power generator[J]. Chinese Journal Semiconductors, 2005, 26(12):2440-2444.
[11] MATSUBARA K. The performance of a segmented thermoelectric convertor using Yb-based filled skutterudites and Bi2Te3-based materials[C] // MRS Proceedings. London, England: Cambridge University Press, 2001, 691:1-9.
[12] RUTTANAPUN C, JINDAJITAWAT P, BURANASIRI P, et al. Preparation, characterization and finite element computation of Cu(Al1/2Fe1/2)O2 delafossite oxide thermoelectric generator module[J]. Integrated Ferroelectrics, 2014, 156(1):102-104.
[13] LIU W, KIM H S, CHEN S, et al. N-type thermoelectric material Mg2Sn0.75Ge0.25for high power generation[J]. Proceedings of the National Academy of Sciences, 2015, 112(11):3269-3274.
[14] 全睿,谭保华,唐新峰,等. 汽车尾气温差发电装置中热电器件的试验研究[J]. 中国机械工程,2014,25(5):705-709. QUAN Rui, TAN Baohua, TANG Xinfeng, et al. Experimental study on thermoelectric modules used in automobile exhaust thermoelectric generator[J]. China Mechanical Engineering, 2014, 25(5):705-709.
[15] THACHER E, HELENBROOK B, KARRI M. et al. Testing of an automobile exhaust thermoelectric generator in a light truck[J]. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2007, 221(1):95-107.
[16] DAI Dan, ZHOU Yixin, LIU Jing. Liquid metal based thermoelectric generation system for waste heat recovery[J]. Renewable Energy, 2011, 36(12):3530-3536.
[17] WOJCIECHOWSKI T, SCHMODT M, ZYBALA R, et al. Comparison of waste heat recovery from the exhaust of a spark ignition and a diesel engine[J]. Journal of Electronic Materials, 2010, 39(9):2034-2038.
[18] GOULD C A, SHAMMAS N Y A, GRAINGERS, et al. Thermoelectric power generation: properties, application and novel TCAD simulation[C] // Power Electronics and Applications(EPE 2011), Birmingham, England: IEEE Press, 2011: 1-10.
[19] 褚泽. 废热半导体温差发电技术的研究与开发[D].重庆:重庆大学,2008. CHU Ze. Development and investigation of thermoelectric based on waster heat[D]. Chongqing: Chongqing University, 2008.
[20] 邓亚东,范韬,郭珣,等.汽车尾气温差发电装置及热电模块的布置研究[J].武汉理工大学学报(信息与管理工程版),2010,32(2):265-267. DENG Yadong, FAN Tao, GUO Xu, et al. Arrangement of TEG device and thermoelectric module[J]. Journal of Wuhan University of Technology(Information & Management Engineering), 2010, 32(2):265-267.
[21] 周泽广,朱冬生,吴红霞,等.温差发电器的传热特性分析与实验研究[J]. 华南理工大学学报(自然科学版),2011,39(11):47-52. ZHOU Zeguang, ZHU Dongsheng, WU Hongxia, et al. Heat transfer characteristic analysis and experimental investigation of thermoelectric generator[J]. Journal of South China University of Technology(Natural Science Edition), 2011, 39(11):47-52.
[22] 许进峰. ANSYS Workbench 15.0完全自学一本通[M].北京: 电子工业出版社, 2014:125-140.
[1] SONG Kai-ming1, YU Jian2, DING Dong-sheng1, CHU Shao-ling3, ZHOU Yu-qiang4. The optimization of rowing bote type based on VOF method [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2012, 42(4): 67-73.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
[1] CHENG Daizhan, LI Zhiqiang. A survey on linearization of nonlinear systems[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(2): 26 -36 .
[2] WANG Yong, XIE Yudong. Gas control technology of largeflow pipe[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(2): 70 -74 .
[3] LIU Xin 1, SONG Sili 1, WANG Xinhong 2. [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(2): 98 -100 .
[4] . [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(2): 104 -107 .
[5] CHEN Huaxin, CHEN Shuanfa, WANG Binggang. The aging behavior and mechanism of base asphalts[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(2): 125 -130 .
[6] . [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(2): 131 -136 .
[7] LI Shijin, WANG Shengte, HUANG Leping. Change detection with remote sensing images based on forward-backward heterogenicity[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(3): 1 -9 .
[8] ZHAO Ke-Jun, WANG Xin-Jun, LIU Xiang, CHOU Yi-Hong. Algorithms of continuous top-k join query over structured overlay networks[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2009, 39(5): 32 -37 .
[9] ZHAO Zhi-guang,WANG Deng-jie,TIAN Yun-fei . Roadbed settlement based on the gray theory[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2007, 37(3): 86 -88 .
[10] YAO Zhan-yong,SHANG Qing-sen,ZHAO Zhi-zhong,JIA Zhao-xia . The influence analysis of the semirigid asphalt pavement configuration stress and distortion by interface conditions[J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2007, 37(3): 93 -99 .
Copyright 2018 © Editorial office of Journal of Shandong University (Engineering Science)
Supported by Beijing Magtech Co.Ltd