JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE) ›› 2014, Vol. 44 ›› Issue (4): 64-69.doi: 10.6040/j.issn.1672-3961.0.2014.051

Previous Articles     Next Articles

Simulation and analysis on performances of dish solar thermal power system based on Stirling engine

DING Shengping, WANG Yongzheng, LYU Ruijie, WU Yue, JIANG Lei   

  1. School of Energy and Power Engineering, Shandong University, Jinan 250061, Shandong, China
  • Received:2014-02-22 Revised:2014-06-26 Published:2014-02-22

PDF (PC)

1215

Abstract: Through an analysis on concentrator, receiver and Stirling engine, the functional relationships among each modules were obtained, the energy tranfer model of dish solar thermal power system was built. The simulation and analysis on the performances of dish Stirling system were carried out under different climates conditions by using energy transfer model. The results showed that the engine pressure exhibited linear relationship with the solar direct normal insolation; when the hot-head temperature kept in setting range, the net output power of the system increased with the engine pressure increasing; while the ambient temperature decreased, the Stirling engine efficiency increased and the net output power increased slightly; while the wind speed increased, the receiver efficiency and the net output power increased.

Key words: solar thermal power, net output power, direct normal insolation, simulation, Stirling engine

CLC Number: 

  • TK51
[1] MANCINI T, HELLER P, BUTLER B, et al. Dish stirling systems: an overview of development and status[J]. Journal of Solar Energy Engineering, 2003, 125(2):135-151.
[2] KADIR A, ABIDIN M Z, RAFEEU Y, et al. Prospective scenarios for the full solar energy development in Malaysia[J]. Renewable and Sustainable Energy Reviews, 2010, 14(9):3023-3031.
[3] NEPVEU F, FERRIERE A, BATAILLE F. Thermal model of a dish/stirling systems[J]. Solar Energy, 2009, 83(1):81-89.
[4] PAUL R F. Stirling dish system performance prediction model[D]. Madison:University of Wisconsin, 2008.
[5] ANDRAKA C E. Alignment strategy optimization method for dish stirling faceted concentrators[C]//Energy sustainability. Long Beach: ASME, 2007:1047-1054.
[6] SINGH N, GIBBS B M, KAUSHIK S C. Effect of solar collector design parameters on the operation of solar Stirling power system[J]. International Journal of Energy Research, 1997, 21(2):195-200.
[7] HARRIS J A, LENZ T G. Thermal performance of solar concentrator/cavity receiver systems[J]. Solar Energy, 1985, 34(2):135-142.
[8] HOGAN Jr R E.AEETES-A solar reflux receiver thermal performance numerical model[J]. Solar Energy, 1994, 52(2):167-178.
[9] STINE W B, MCDONALD C G. Cavity receiver heat loss measurements[C]//Solar World Congress. Kobe:ISES, 1989.
[10] MORAN M J, SHAPIRO H N, BOETTNER D D, et al. Fundamentals of engineering thermodynamics[M]. Hoboken:John Wiley & Sons, 2010.
[11] MARTIN W R. Stirling engine design manul[R]. Alexandria:NASA, 1983.
[12] URIELI I, BERCHOWITZ D M. Stirling cycle engine analysis[M]. Bristol:Adam Hilger, 1984.
[13] REINALTER W, GINESTE J M, FERRIERE A, et al. Detailed performance analysis of a 10 kW dish/stirling system[J]. Journal of Solar Energy Engineering, 2008, 130(1):11-13.
[14] 顾根香,金东寒.斯特林动态特性的研究[J].内燃机学报,2000,18(3):305-307. GU Genxiang, JIN Donghan. Study on the stirling engine dynamic characteristics[J]. Transactions of Csice, 2000, 18(3):305-307.
[15] 李明震,董金钟.碟式斯特林发电系统性能分析模型与仿真[J].北京航空航天大学学报,2013,39(3):381-385. LI Mingzhen, DONG Jinzhong.Dish-stirling power generation system performance prediction model and simulation analysis[J].Journal of Beijing University of Aeronautics and Astronautics, 2013, 39(3):381-385.
[16] IGO J, ANDRAKA C E. Solar dish field system model for spacing optimization[C]//Energy Sustainability. Long Beach: ASME, 2007:981-987.
[17] KONGTRAGOOL B, WONGWISES S.A review of solar powered stirling engines and low temperature differential stirling engines[J]. Renewable and Sustainable Energy Reviews, 2003, 7(2):131-154.
[1] SONG Shizhan, WANG Chuanyong, KANG Wenwen, ZHANG Jian, YAN Honghua, LI Peng. PV installed capacity planning for power distribution network based on time series production simulation [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(5): 131-136.
[2] WANG Zhongxiao, CUI Xinzhuang, CUI Sheqiang, ZHANG Lei, CHE Huaqiao, SU Junwei. The influence of soil-cement pile deterioration and modification in salt-water area on road composite foundation [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(4): 69-77.
[3] HE Zhengyi, ZENG Xianhua, GUO Jiang. An ensemble method with convolutional neural network and deep belief network for gait recognition and simulation [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(3): 88-95.
[4] DAI Shiyu, LIU Shuqin. Estimation of speed and acceleration of the Maglev platform by state observer [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(2): 114-120.
[5] SONG Guijie. Deformation characteristic and instability analysis for shallow soft rock section during tunnel-entering construction [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(2): 53-60.
[6] WANG Danhua, ZHANG Guanmin, LENG Xueli, XU Mengna, HAN Yuanyuan. The numerical simulation of two-phase flow distribution characteristics in T-tube [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(1): 89-95.
[7] ZHANG Bohan, CHEN Zheming, FU Jianghua, CHEN Bao. Self-adaption acceleration slip regulation control of four-wheel independently-driving electric vehicle [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(1): 96-103.
[8] SHAO Jian, WEI Peiyu, CHEN Ping, LIANG Fengqiang, MENG Chao. A traveling wave fault location method for T-type transmission line based on combined traveling wave principle [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(1): 117-123.
[9] ZHANG Shuangsheng, QIANG Jing, LIU Xikun, LIU Hanhu, ZHU Xueqiang. Inverse problems of pollution source identification based on Bayesian-DE [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2018, 48(1): 131-136.
[10] SHI Fang, ZHANG Hengxu, ZHANG Lei. [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2017, 47(6): 151-156.
[11] XIA Mengran, LI Wei, FENG Xiao, ZHU Guangxuan, LI Xia. Grouting reinforcement and excavation stability on super-shallow buried and water-rich sand stratum subway transverse channel [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2017, 47(2): 47-54.
[12] CUI Qing, ZHANG Changqiao, XIU Jianxin, XU Shiming, LU Lili. Molecular dynamic simulation on the mechanism of viscosity reduction to asphaltene and resin in heavy oil [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2017, 47(2): 123-130.
[13] . Experiment and numerical simulation for surface roughness of 2024 aluminum alloy treated by shot peening [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2017, 47(1): 84-89.
[14] LYU Guoren, ZHANG Qun, NIU Ben, GAO Quanting, WU Zhaoshou. The effects of pile foundation of high-rise building on adjacent structures [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2017, 47(1): 48-58.
[15] CHEN Yucheng, SUN Qiang, MIAO Qiang, BAI Shuzhan, LI Guoxiang. Design and development of test bench for hybrid electric vehicle powertrain [J]. JOURNAL OF SHANDONG UNIVERSITY (ENGINEERING SCIENCE), 2017, 47(1): 119-124.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
Copyright 2018 © Editorial office of Journal of Shandong University (Engineering Science)
Supported by Beijing Magtech Co.Ltd