您的位置:山东大学 -> 科技期刊社 -> 《山东大学学报(工学版)》

山东大学学报(工学版)

• 论文 • 上一篇    下一篇

局部应力应变疲劳的能量方法

徐 楠,陈举华   

  1. 山东大学机械工程学院,山东济南250061
  • 收稿日期:2005-06-28 修回日期:1900-01-01 出版日期:2006-02-24 发布日期:2006-02-24
  • 通讯作者: 陈举华

Energy method of local stress and strain fatigue

XU Nan,CHEN Ju-hua   

  1. School of Mechanical Engineering,Shandong University,Jinan 250061,China
  • Received:2005-06-28 Revised:1900-01-01 Online:2006-02-24 Published:2006-02-24
  • Contact: CHEN Ju-hua

摘要: 应用Neuber准则分析弹塑性材料缺口件时局部应力应变估计过高,因此预测初始寿命常给出过于保守的结论.由于当量应变能密度(Equivalent strain energy density, ESED)准则在Neuber准则的塑性变形项上增加了系数,局部应力应变估计结果更为准确.基于能量方法讨论了循环加载下材料的塑性应变能密度,发现ESED准则相比Neuber准则多考虑了塑性应变能密度,这是ESED准则局部应变场估计值远低于Neuber准则的估计值的能量理论基础.疲劳试验的结果验证了以上结论.

关键词: 疲劳, 能量理论, Neuber准则, 当量应变能密度准则

Abstract: Analysis of notched specimen of elasticplastic materials by using Neuber rule always lead to over high estimated values of local stress and strain. So conservative initiallife results were usually obtained. Since the coefficient was added to equivalent strain energy density rule on the basis of the plastic deformation item of Neuber rule, the local stress and strain estimation results should be more accurate. According to energy method, elasticplasticity strain energy density of material in the case of cyclic loading was discussed. It was discovered that the plastic strain density was taken into account by the ESED rule, and this was the energy theory basis for the further lower values of local stresses estimated by ESED rule than those obtained by Neuber rule. The above conclusion agreed well with fatigue test.

Key words: energy theory, Neuber rule, ESED rule , fatigue

中图分类号: 

  • O346.2
[1] 刘立君, 张红兴, 张伟杰, 王刚, 齐萌. 雨刮器压铸模具激光填丝焊修复性能[J]. 山东大学学报(工学版), 2015, 45(3): 73-79.
[2] 朱登元1,2,姚占勇1*,管延华1,庄培芝1. 路面结构平衡的破坏接近度分析[J]. 山东大学学报(工学版), 2012, 42(6): 74-79.
[3] 杨永顺1,王林2,高雪池1,贾海庆3,韦金城2 . 永久路面结构应变分布及疲劳损伤分析[J]. 山东大学学报(工学版), 2009, 39(2): 118-124.
[4] 徐楠 王胜春 王秀叶. 一种改进的当量应变能密度方法[J]. 山东大学学报(工学版), 2008, 38(6): 118-120.
[5] 姚占勇,吴世美,陈超 . 横向路拱引起路面疲劳破坏的差异研究[J]. 山东大学学报(工学版), 2007, 37(6): 87-90 .
[6] 胡云萍,毛华永,胡玉平,李国祥 . 6160柴油机曲轴三维有限元分析[J]. 山东大学学报(工学版), 2006, 36(2): 99-103 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!