您的位置：山东大学 -> 科技期刊社 -> 《山东大学学报（工学版）》

山东大学学报(工学版) ›› 2016, Vol. 46 ›› Issue (2): 101-107.doi: 10.6040/j.issn.1672-3961.0.2015.048

• • 上一篇    下一篇

岩质边坡锚杆应力监测离心模型试验研究

郭永建1,曹周阳2,生丽娟1   

  1. 1. 青岛国信胶州湾交通有限公司, 山东 青岛 266500;2. 郑州航空工业管理学院土木建筑工程学院, 河南 郑州 450015
  • 收稿日期:2015-03-06 出版日期:2016-04-20 发布日期:2015-03-06
  • 作者简介:郭永建(1985— ),男,山东临沂人,工程师,博士,主要研究方向为边坡与隧道工程的锚固.E-mail: guoyongjian1985@163.com
  • 基金资助:
    国家自然科学基金资助项目(41272285)

The centrifugal model test of cable stress monitoring for rock slope

GUO Yongjian1, CAO Zhouyang2, SHENG Lijuan1   

  1. 1. Qingdao Guoxin Jiaozhou Bay Traffic Co.Ltd, Qingdao 266500, Shandong, China;
    2. Institute of Civil Engineering and Architecture, Zhengzhou Institute of Aeronautical Industry Management, Zhengzhou 450015, Henan, China
  • Received:2015-03-06 Online:2016-04-20 Published:2015-03-06

PDF (PC)

1237

摘要： 基于离心模型试验方法,以m(重晶石粉)∶m(石英砂)∶m(石膏)∶m(水)=1.50∶1.00∶0.25∶0.50的质量比制备岩石替代材料,并制作3类典型岩质边坡的试验模型,通过应力监测方法研究岩质边坡失稳前的应力变化规律。试验结果为3类岩质边坡失稳前的应力变化曲线均较为平缓,监测预警易于把握,且具有相通性,均可采用Logistic曲线形式进行拟合;层状岩质边坡监测应以滑动面下部监测为主,结构面控制岩质边坡的破坏形式主要以拉剪破坏为主,试验选取的边坡类型监测应以上部结构面为主,碎裂结构岩质边坡应以边坡上部监测为主。综合离心模型试验结果表明,采用应力监测的方法评价公路岩质边坡的稳定性具有可行性。

关键词: 岩质边坡, 应力监测, 离心模型试验, 稳定性评价, Logistic曲线

Abstract: The centrifugal model test was taken to study the stress monitoring for the three typical types rock slopes,with the similar material mass ratio of quartz sand, plaster, and water as 1.50∶1.00∶0.25∶0.50. Test results showed that stress curves of the three typical types rock slopes were more flatted before the slope failure, stress monitoring and early warning were easy to grasp, and with similar properties,stress curves were used in the form of logistic curves fitting. Stress monitoring site of stratified rock slope should be mainly located in lower part of sliding surface. Failure mode of rock slope controlled by structural plane was mainly in the form of tensile shear,and test stress monitoring site of rock slope should be mainly located in upper part of structure plane,stress monitoring site of cataclastic structure rock slopes should be mainly located in upper part of slope. Centrifuge model test results showed that it was feasible to apply stress monitoring method to evaluate the rock slope stability.

Key words: stress monitoring, stability evaluation, logistic curves, rock slope, centrifugal model test

中图分类号: 

  • U416.1+4
[1] 曹洁,张嘎,王丽萍. 土钉加固黏性土坡加载的离心模型试验研究[J]. 岩土力学, 2012, 33(6):1696-1702. CAO Jie, ZHANG Ga,WANG Liping. Centrifugal model test on behavior of strip footing on soil nail-reinforced cohesive soil slopes[J]. Rock and Soil Mechanics, 2012, 33(6):1696-1702.
[2] 李明,张嘎,胡耘, 等. 边坡开挖破坏过程的离心模型试验研究[J]. 岩土力学, 2010, 31(2):366-370. LI Ming, ZHANG Ga, HU Yun, et al. Centrifugal model test on behavior of strip footing on soil nail-reinforced cohesive soil slopes[J]. Rock and Soil Mechanics, 2010, 31(2):366-370.
[3] TOHARI A, NISHIGAKI M, KOMATSU M.Laboratory rainfall-induced slope failure with moisture content measurement[J]. Journal of Geotechnical and Geoenvironmental Engineering, 2007, 133(5):575-587.
[4] 周浩,郭永建,郭风明,等. 利用离心模型试验求解岩质边坡抗滑稳定安全系数[J]. 南水北调与水利科技, 2012,10(1):27-30. ZHOU Hao, GUO Yongjian, GUO Fengming, et al. Using geotechnical centrifuge model test to solve rock slope safety factor against sliding[J]. South-to-North Water Diversion and Water Science & Technology, 2012, 10(1):27-30.
[5] BRAY J W, GOODMAN R E. The theory of base friction models[J]. International Journal of Rock Mechanics and Mining Science & Geomechanics Abstracts, 1981, 18:453-468.
[6] GOODMAN R E. Introduction to rock mechanics[M]. New York:John Willey and Sons Incorporated, 1989.
[7] GOODMAN R E. Block theory and its application[J]. Geotechnique, 1995, 45(3):383-422.
[8] STEWART D P, ADHIKARY D P, JEWELL R J. Studies on the stability of model rock slopes[C] //Proceedings of the InternationalConference on Centrifuge 94. Singapore: A A Balkema, 1994: 629-634.
[9] CHEN Z Y, ZHANG J H, WANG W X. Centrifuge modeling for rock slopes[C] //Physical Modelling in Geotechnics-6th ICPMG'06. Hong Kong, China: Taylor & Francis Group, 2006:19-28.
[10] ZHANG J H, CHEN Z Y. Centrifuge modeling of rock slopes susceptible to block toppling[J]. Rock Mechanics and Rock Engineering, 2007, 40(4):363-382.
[11] 汪小刚,张建红,赵毓芝, 等. 用离心模型研究岩石边坡的倾倒破坏[J]. 岩土工程学报,1996,18(5):14-21. WANG Xiaogang, ZHANG Jianhong, ZHAO Yuzhi, et al. Investigations on mechanism of slope toppling failure by centrifuge model testing[J]. Chinese Journal of Geo-technical Engineering, 1996, 18(5):14-21.
[12] 陈祖煜, 汪小刚, 杨健, 等.岩石边坡稳定分析—原理·方法·程序[M]. 北京:中国水利水电出版社, 2005.
[13] 邓卫东, 吴光勇, 唐树名. 路堑边坡破坏机理的试验与计算分析[J].中国公路学报,2001,14(3):21-23. DENG Weidong, WU Guangyong, TANG Shuming. Test and calculation on the failure of cutting slope[J]. China Journal of Highway and Transport, 2001, 14(3):21-23.
[14] 唐红梅,陈洪凯,曹卫文. 顺层岩体边坡开挖过程模型试验[J]. 岩土力学, 2011, 32(2):435-440. TANG Hongmei, CHEN Hongkai, CAO Weiwen. Model experiment in excavation of rock bedding[J]. Rock and Soil Mechanics, 2011, 32(2):435-440.
[15] 冯振,殷跃平,李滨, 等. 斜倾厚层岩质滑坡视向滑动的土工离心模型试验[J].岩石力学与工程学报, 2012, 31(5):890-897. FENG Zhen, YIN Yueping, LI Bin, et al. Centrifuge modeling of apparent dip slide from oblique thick bedding rock landslide[J]. Chinese Journal of Rock Mechanics and Engineering, 2012, 31(5):890-897.
[16] 张强勇, 李术才, 郭小红, 等. 铁晶砂胶结新型岩土相似材料的研制及其应用[J]. 岩土力学, 2008, 29(8):2126-2130. ZHANG Qiangyong, LI Shucai, GUO Xiaohong, et al. Research and development of new typed cementitious geotechnical similar material for iron crystal sand and its application[J]. Rock and Soil Mechanics, 2008, 29(8):2126-2130.
[17] 张宁,李术才,李明田,等. 新型岩石相似材料的研制[J]. 山东大学学报(工学版), 2009, 39(4):149-154. ZHANG Ning, LI Shucai, LI Mingtian, et al. Development of a new rock similar material[J]. Journal of Shandong University(Engineering Science), 2009, 39(4):149-154.
[18] 王汉鹏, 李术才, 张强勇, 等. 新型地质力学模型试验相似材料的研制[J]. 岩石力学与工程学报, 2006, 25(9):1842-1847. WANG Hanpeng, LI Shucai, ZHANG Qiangyong, et al. Development of a new geomechanical similar material[J]. Chinese Journal of Rock Mechanics and Engineering, 2006, 25(9):1842-1847.
[19] 栗东平, 王谦源, 张增祥, 等. 模拟岩性的相似试验研究[J]. 河北工程大学学报(自然科学版), 2007, 24(2): 12-14. LI Dongping, WANG Qianyuan, ZHANG Zengxiang, et al. Similar test research on property of simulated rock[J]. Journal of Hebei University of Engineering(Natural Science Edition), 2007, 24(2):12-14.
[20] 郭永建, 谢永利, 牛富生. 公路岩质边坡应力监测离心模型试验与应用[J]. 同济大学学报(自然科学版), 2013, 41(11): 1897-1701. GUO Yongjian, XIE Yongli, NIU Fusheng. Centrifugal model test research and application on stress monitoring for highway rock slope[J]. Journal of Tongji University(Natural Science), 2013, 41(11):1697-1701.
[21] 方开泰,许建伦. 统计分析[M].北京:科学出版社,1987.
[22] 李宗坤, 郑晶星, 王伟. 基于双曲线回归三参模型的分析方法研究[J]. 郑州大学学报(工学版), 2002, 23(1):14-17. LI Zongkun, ZHENG Jingxing, WANG Wei. Study on method of analysis based on hyperbola regression three-parameter model[J]. Journal of Zhengzhou University(Engineering Science), 2002, 23(1):14-17.
[23] 王济川,郭志刚. Logistic回归模型—方法与应用[M].北京:高等教育出版社,2001.
[24] 张宏博,李英勇,宋修广. 边坡锚固工程中锚索预应力的变化研究[J]. 山东大学学报(工学版), 2002, 32(6):574-577. ZHANG Hongbo, LI Yingyong, SONG Xiuguang. On prestress variation of cable in reinforcement engineering of slope[J]. Journal of Shandong University(Engineering Science), 2002, 32(6):574-577.
[25] 彭作为, 周创兵, 龚玉峰,等.向家坝进水口高边坡系统锚杆受力状况研究[J].岩土力学, 2006, 27(3):482-486. PENG Zuowei, ZHOU Chuangbing, GONG Yufeng, et al. Mechanical analysis of systematic bolts on rock mass in high side slope at intake of Xiangjiaba Hydropower Station[J]. Rock and Soil Mechanics, 2006, 27(3):482-486.
No related articles found!
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 2018 《山东大学学报(工学版)》编辑部　
地址: 济南市山大南路27号（250100）　 电话: 0531-88366735　 E-mail: xbgxb@sdu.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发