您的位置:山东大学 -> 科技期刊社 -> 《山东大学学报(工学版)》

山东大学学报(工学版) ›› 2010, Vol. 40 ›› Issue (4): 129-132.

• 其它 • 上一篇    下一篇

二级增压系统中高压级压气机性能研究

何义团   

  1. 重庆交通大学机电与汽车工程学院, 重庆 400074
  • 收稿日期:2009-12-10 出版日期:2010-08-16 发布日期:2009-12-10
  • 作者简介:何义团(1977-),男,四川旺苍人,副教授,博士,主要研究方向为内燃机增压技术. E-mail: heyituan@163.com
  • 基金资助:

    重庆市教委科学技术研究资助项目(KJ090421)

Performance of the high pressure stage compressor of a two-stage turbocharging system

HE Yi-tuan   

  1. School of Mechatronics & Automotive Engineering, Chongqing Jiaotong University, Chongqing 400074, China
  • Received:2009-12-10 Online:2010-08-16 Published:2009-12-10

摘要:

为使高低两级压气机达到优化匹配,提高整个二级增压系统的效率,在二级增压系统试验台架上对高压级压气机的性能进行了研究。通过在增压系统中,使新鲜空气首先通过低压级压气机进行预压缩,提高其温度和压力,从而得到高压级压气机的高温高压进口条件。在两级压气机之间设置中冷器,使每一条等转速曲线,高压级压气机进口温度保持不变。试验结果表明,由于进口温度提高,压气机折合转速与实际转速相差较大,为达到预定压比,必须进一步提高压气机转速;进口压力大幅度提高是造成高压级压气机折合流量偏小的主要原因;为避免高压级压气机发生喘振,应控制高压级压气机的进口压力。

关键词: 二级增压系统, 高压级压气机, 压气机性能

Abstract:

To make the high pressure(HP) stage compressor and the low pressure(LP) match with optimization and improve the efficiency of the whole two-stage turbo-charging system, the performance of a HP stage compressor was studied on a two-stage turbo-charging system test bench. In the turbo-charging system, the fresh air was first precompressed through the LP stage compressor to get the HP stage compressor′s inlet condition with high pressure & high temperature. An intercooler was set between the HP and LP stage compressors. To each test curve had the same rotation speed, and the inlet temperature of the HP stage compressor was kept unchanged. The test results showed that there was much difference between the corrected speed and actual speed of the HP stage compressor only because the increase of its inlet temperature. In order to get the preconcerted pressure ratio, the speed of the HP stage compressor should be much improved. The corrected air mass flow of HP stage compressor was much less than its measured air mass flow, which was mainly because the great increase of inlet pressure of the HP stage compressor. In order to avoid a surge of the HP stage compressor, its inlet pressure should be controlled.

Key words:  two-stage turbocharging system, high pressure stage compressor, compressor performance

No related articles found!
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 王素玉,艾兴,赵军,李作丽,刘增文 . 高速立铣3Cr2Mo模具钢切削力建模及预测[J]. 山东大学学报(工学版), 2006, 36(1): 1 -5 .
[2] 李 侃 . 嵌入式相贯线焊接控制系统开发与实现[J]. 山东大学学报(工学版), 2008, 38(4): 37 -41 .
[3] 施来顺,万忠义 . 新型甜菜碱型沥青乳化剂的合成与性能测试[J]. 山东大学学报(工学版), 2008, 38(4): 112 -115 .
[4] 孔祥臻,刘延俊,王勇,赵秀华 . 气动比例阀的死区补偿与仿真[J]. 山东大学学报(工学版), 2006, 36(1): 99 -102 .
[5] 陈瑞,李红伟,田靖. 磁极数对径向磁轴承承载力的影响[J]. 山东大学学报(工学版), 2018, 48(2): 81 -85 .
[6] 李可,刘常春,李同磊 . 一种改进的最大互信息医学图像配准算法[J]. 山东大学学报(工学版), 2006, 36(2): 107 -110 .
[7] 季涛,高旭,孙同景,薛永端,徐丙垠 . 铁路10 kV自闭/贯通线路故障行波特征分析[J]. 山东大学学报(工学版), 2006, 36(2): 111 -116 .
[8] 浦剑1 ,张军平1 ,黄华2 . 超分辨率算法研究综述[J]. 山东大学学报(工学版), 2009, 39(1): 27 -32 .
[9] 王丽君,黄奇成,王兆旭 . 敏感性问题中的均方误差与模型比较[J]. 山东大学学报(工学版), 2006, 36(6): 51 -56 .
[10] 孙殿柱,朱昌志,李延瑞 . 散乱点云边界特征快速提取算法[J]. 山东大学学报(工学版), 2009, 39(1): 84 -86 .