您的位置：山东大学 -> 科技期刊社 -> 《山东大学学报（工学版）》

山东大学学报 (工学版) ›› 2021, Vol. 51 ›› Issue (4): 54-60.doi: 10.6040/j.issn.1672-3961.0.2021.036

• • 上一篇    下一篇

砂土介质中废旧轮胎加筋条带拉拔特性

李晓亮1,刘源2,李玉鑫1,江建宏3,魏琨1,张宏博2*   

  1. 1.山东高速股份有限公司, 山东 济南 250014;2.山东大学齐鲁交通学院, 山东 济南 250061;3.山东省交通规划设计院集团有限公司, 山东 济南 250031
  • 发布日期:2021-08-18
  • 作者简介:李晓亮(1970— ),男,山东滨州人,硕士,主要研究方向为改扩建高速公路路基沉降控制及固废资源利用技术. E-mail:lixiaoliang_sd@163.com. *通信作者简介:张宏博(1977—),男,山东金乡人,副教授,博士,主要研究方向为边坡与路基支挡. E-mail:zhanghongbo@sdu.edu.cn
  • 基金资助:
    山东省重点研发计划(2019GSF109045)

The pullout features of reinforced strips of waste tires in sandy media

LI Xiaoliang1, LIU Yuan2, LI Yuxin1, JIANG Jianhong3, WEI Kun1, ZHANG Hongbo2*   

  1. 1. Shandong Hi-Speed Co., Ltd., Jinan 250014, Shandong, China;
    2. School of Qilu Transportation, Shandong University, Jinan 250061, Shandong, China;
    3. Shandong Provincial Communications Planning and Design Institute Group Co., Ltd., Jinan 250031, Shandong, China
  • Published:2021-08-18

PDF (PC)

406

摘要： 为减少废旧轮胎大量堆放对环境造成的严重污染及潜在安全隐患,基于废旧轮胎良好的抗拉伸、耐老化及界面粗糙等特性,本研究提出将废旧轮胎切割成条,制成加筋条带,用作土工加筋材料的新型利用方法。通过调整砂土不同密实度条件,对比开展废旧轮胎条带及土工格栅拉拔特性试验研究。结果表明,砂土介质中废旧轮胎条带达到极限拉拔力之前,拉拔位移随拉拔力的增长而线性增长;极限拉拔力统计表明,加筋条带界面抗剪强度符合摩尔-库仑强度准则,并由此建立界面抗剪强度与界面摩擦角及似黏聚力的线性关系。通过对比土工格栅加筋性能,发现废旧轮胎条带的剪应力峰值约为土工格栅的2.5~3.2倍;达到剪应力峰值所需要的位移约为土工格栅的5倍。研究成果验证了废旧轮胎条带作为加筋材料的可行性,为进一步开展理论研究及工程应用奠定了基础。

关键词: 废旧轮胎条带, 土工格栅, 砂土介质, 拉拔试验, 界面强度

Abstract: In order to reduce the serious pollution to the environment and the potential safety hazards caused by the large amount of accumulated waste tires, a new method was proposed by cutting tires into strips to utilize the strips as reinforced material due to the good tensile stiffness, strong aging resistance and rough interface properties of waste tire. By adjusting the conditions of different density of sand, a comparative study on the pull-out characteristics of waste tire strips and geogrids was carried out. It was observed that the pullout load-displacement curve showed a tendency of linear increase before the strip of waste tires in the sand medium reaching the maximum pullout resistance. The static analysis of peak pullout resistance revealed that the shear properties of the tire strip-sand interface complied with mohr-coulomb criterion, thus the linear relationship between interface shear strength and interface friction angle, like-cohesion was established. By comparing the reinforcement performance of geogrid, it was found that the peak shear stress of scrap tire strip was about 2.5~3.2 times that of geogrid; the displacement of the peak shear stress was about 5 times that of geogrid. The research results verified the feasibility of used tire strips as reinforcing materials, and laid the foundation for further theoretical research and engineering applications.

Key words: waste tire strip, geogrid, sand media, pullout test, interface strength

中图分类号: 

  • U414
[1] 李钊.我国废旧轮胎资源化的现状、问题与对策[J].低碳世界,2018(6):27-28. LI Zhao. Current situation, problems and countermeasures of recycling of waste tires in China[J]. Low Carbon World, 2018(6):27-28.
[2] 徐微.论废旧轮胎的资源利用及北京废旧轮胎综合利用产业化发展建议[J].中国资源综合利用,2018,36(12):64-66. XU Wei. Discussion on resource utilization of waste tire and suggestion on industrialization development of comprehensive utilization of waste tire in Beijing[J]. China Resources Comprehensive Utilization, 2018,36(12):64-66.
[3] LIU L, CAI G, ZHANG J, et al. Evaluation of engineering properties and environmental effect of recycled waste tire-sand/soil in geotechnical engineering: a compressive review[J]. Renewable and Sustainable Energy Reviews, 2020, 126: 109831.
[4] 蔡磊磊.我国汽车废旧轮胎的回收利用的现状及参考性建议[J]. 智库时代, 2018(30):194-195. CAI Leilei. The current situation of the recycling of automobile waste tires in China and reference suggestions[J]. Think Tank Era, 2018(30):194-195.
[5] 曾玉珍, 廖正环. 废旧轮胎在国外道路工程中的应用[J]. 国外公路, 2000, 20(1):39-41. ZENG Yuzhen, LIAO Zhenghuan. The application of waste tires in foreign road projects [J]. Journal of Foreign Highway, 2000, 20(1):39-41.
[6] DALTON D C, HOBAN K M. Tyre walls in highway construction[J]. Highway Engineer, 1982, 29(2): 2-9.
[7] KIM K S, YOON Y W, YOON G L, et al. Pullout behavior of cell-type tires in reinforced soil structures[J]. Ksce Journal of Civil Engineering, 2011, 15(7): 1209-1217.
[8] ZORNBERG J G, CABRAL A R, VIRATJANDR C. Behaviour of tire shred sand mixtures[J]. Canadian Geotechnical Journal, 2015, 41(2): 227-241.
[9] BEKHITI M, TROUZINE H, RABEHI M. Influence of waste tire rubber fibers on swelling behavior, unconfined compressive strength and ductility of cement stabilized bentonite clay soil[J]. Construction and Building Materials, 2019, 208: 304-313.
[10] GILL G, MITTAL R K. Use of waste tire-chips in shallow footings subjected to eccentric loading-an experimental study[J]. Construction and Building Materials, 2019, 199: 335-348.
[11] TANCHAISAWAT T, BERGADO D T, VOOTTIP-RUEX P, et al. Interaction between geogrid reinfor-cement and tire chip—sand lightweight backfill[J]. Geotextiles and Geomembranes, 2010, 28(1): 119-127.
[12] LI L H, CHEN Y J, FERREIRA P M V, et al. Experimental investigations on the pull-out behavior of tire strips reinforced sands[J]. Materials, 2017, 10(7): 707.
[13] REDDY S B, KRISHNA A M, REDDY K R. Sustainable utilization of scrap tire derived geomaterials for geotechnical applications[J]. Indian Geotechnical Journal, 2018, 48(2): 251-266.
[14] 招商局重庆交通科研设计院有限公司. 公路土工合成材料应用技术规范:JTG/T D32—2012. 北京:人民交通出版社,2012.
[15] 交通运输部公路科学研究院.公路土工试验规程:JTG3420—2020.北京:人民交通出版社,2020.
[16] 杨广庆, 隋传毅. 土工格栅与土体界面摩擦特性试验研究[J]. 石家庄铁道大学学报(自然科学版), 2010, 23(2):46-52. YANG Guangqing, SUI Chuanyi. Experimental research on interface friction characteristics of geogrids and soil[J]. Journal of Shijiazhuang Tiedao University(Natural Science Edition), 2010, 23(2):46-52.
[17] 刘飞禹, 林旭, 王军. 砂土颗粒级配对筋土界面抗剪特性的影响[J]. 岩石力学与工程学报, 2013, 32(12):2575-2582. LIU Feiyu, LIN Xu, WANG Jun. Influence of particle-size gradation on shear behavior of geosynthetics and sand interface[J]. Chinese Journal of Rock Mechanics and Engineering, 2013, 32(12):2575-2582.
[1] 江健宏,舒晓锐,刘志鲲,孙杰,荆树举,张宏博. 废旧轮胎碎片(TDA)复合填料中竖向锚定板承载特性[J]. 山东大学学报 (工学版), 2023, 53(6): 92-99.
[2] 章清涛,刘晓威,高健,孙玉海,闫庆亮,刘源,王昊. 坡顶荷载作用下废旧轮胎条带加筋边坡承载特性[J]. 山东大学学报 (工学版), 2022, 52(3): 70-79.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
[1] 王素玉,艾兴,赵军,李作丽,刘增文 . 高速立铣3Cr2Mo模具钢切削力建模及预测[J]. 山东大学学报(工学版), 2006, 36(1): 1 -5 .
[2] 张永花,王安玲,刘福平 . 低频非均匀电磁波在导电界面的反射相角[J]. 山东大学学报(工学版), 2006, 36(2): 22 -25 .
[3] 孔祥臻,刘延俊,王勇,赵秀华 . 气动比例阀的死区补偿与仿真[J]. 山东大学学报(工学版), 2006, 36(1): 99 -102 .
[4] 来翔 . 用胞映射方法讨论一类MKdV方程[J]. 山东大学学报(工学版), 2006, 36(1): 87 -92 .
[5] 余嘉元1 , 田金亭1 , 朱强忠2 . 计算智能在心理学中的应用[J]. 山东大学学报(工学版), 2009, 39(1): 1 -5 .
[6] 季涛,高旭,孙同景,薛永端,徐丙垠 . 铁路10 kV自闭/贯通线路故障行波特征分析[J]. 山东大学学报(工学版), 2006, 36(2): 111 -116 .
[7] 秦通,孙丰荣*,王丽梅,王庆浩,李新彩. 基于极大圆盘引导的形状插值实现三维表面重建[J]. 山东大学学报(工学版), 2010, 40(3): 1 -5 .
[8] 王静,李玉江,张晓瑾, 毕研俊,陈位锁 . 粉煤灰去除水中活性紫KN-B[J]. 山东大学学报(工学版), 2006, 36(6): 100 -103 .
[9] 孙殿柱,朱昌志,李延瑞 . 散乱点云边界特征快速提取算法[J]. 山东大学学报(工学版), 2009, 39(1): 84 -86 .
[10] 杨发展1 ,艾兴1 ,赵军1 ,侯建锋2 . ZrO2含量对WC基复合材料的力学性能和微观结构的影响[J]. 山东大学学报(工学版), 2009, 39(1): 92 -95 .
版权所有 © 2018 《山东大学学报(工学版)》编辑部　
地址: 济南市山大南路27号（250100）　 电话: 0531-88366735　 E-mail: xbgxb@sdu.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发